Built from the same high quality non-magnetic stainless steel as the race car systems, by the very same craftsmen, and in the exact same Derbyshire factory, these new parts may be podium-ready, but they have been designed to walk the fine line between power and refinement. This exhaust is based around a carefully optimised 3” (76mm) section tube for maximum power and torque gains with a refined throttle response throughout the rev range. The valves in this system connect to the factory wiring and will operate as they do from the factory. This exhaust system is not resonated and is the loudest of the three available Milltek exhaust systems for the VW Arteon. Parts Included: Adapter to factory downpipe (not required if using an aftermarket downpipe) Front resonator bypass pipe Y-Pipe section Left side muffler Right side muffler Valved outlet pipes Please note that no tips are included with this exhaust. Instead, the exhaust system routes to the "tips" built into the factory equipped rear valance.

More than 29 years of continuous exhaust development and technical expertise are drawn upon to develop the ultimate Milltek Sport range of performance products, offering an ever-expanding comprehensive selection of performance exhausts which build on the successes of key marques like Audi, Volkswagen, Porsche, BMW and Nissan. Milltek Sport exhausts are produced in high quality type-304 aircraft grade stainless steel. This material is anti-magnetic (other manufacturers' stainless steel may not be) and is less susceptible to discolouration. This quality of stainless steel is used on all pipework and the total construction of the silencer. Mandrel bending ensures full flow bends for better gas flow and Milltek systems are increased in bore to ensure ultimate performance without the loss of mid-range torque. All Milltek exhausts are designed, developed and manufactured in-house in the UK.